AR4 / AR4B

1. 2M-pixel 1080p camera
2. Power LED light (Blue)
3. 36 Hidden infrared LEDs
4. Light detection
5. DC power connector (5.5 x 2.0mm) 12V 1A
6. PoE RJ45 connector (POE Switch : IEEE 802.3af/at)
7. Factory reset

2M-pixel 1080p camera

★ Make sure your smart phone is connected to the same Wi-Fi network.

1. Connect the power adapter to the device then plug into the power outlet.
2. Connect the RJ45 Ethernet cable to the device then plug into Wi-Fi AP router.
3. The camera is now ready for APP setup when the blue power LED indicator begins to flash.

★ Please refer to "Setup via PoE" for alternative setup method

Select AR4 / AR4B in the APP then follow the instructions shown.

★ Please refer to the FAQ page for more informationon how to share the viewer of administrator rights toother smart phone devices.

1. Select AR4 / AR4B in the APP then follow the instructions shown.
2. Please make sure that your smart phone is connected to the same Wi-Fi SSID network.
3. After selecting the camera model you will be given the Internet setup option.
4. Please select Auto-Detection.
5. The AMID will appear on the next screen. Please select to complete setup process.

Note: AMID can be found on the device label.

Congratulations! Your AR4 / AR4B is set up and ready to go.

Note: The camera is designed for easy DIY installation but if you need local assistance, please visit www.SoteriaAi.com to locate a
professional installer near you.

★ Please be sure your device is running on the latest firmware.

Camera offers 110° viewing angle. The best area for detection is within 5 meters (16.4 ft) from the camera position.

1. When mounting the camera on the wall, please be sure the vertical is do not exceed over 120° in angle.
2. When mounting the camera on the ceiling, please be sure the vertical axis do not exceed over 110° in angle.

Camera needs to be mounted at least 2 meters(6.5 ft) above the ground. Try to avoid exposure to direct sunlight and rain.

Use the L shaped hex key size (2.5mm) to adjust the camera to the desired monitoring position then fasten the nuts to secure camera angle.

1. 1st axis : to pan camera left and right
2. 2nd axis : to tilt the camera up or down
3. 3rd axis: to rotate the camera

Note: Please avoid rotating the camera to more than 360°

4. Camera position when mounted against the wall

5. Camera position when mounted on the ceiling

1. Place the drill template in the desired position on the wall.
2. Drill into the 3 cross marked holes.

3. Be sure to use the provided wall anchors to insert into wall.

4. Mount the camera over the holes then fasten the mounting screw into

the anchors.

• Blue LED indicates power status
• Solid Blue LED : Device is powered on 
• Flashing Blue LED : Camera is being accessed remotely by user of the installation

Note: Please be sure the camera angle is mounted correctly.

1. Make sure your camera is powered on.
2. ress and hold the reset button for about 5 to 10 seconds. Reset is complete when the green Wi-Fi indicator begins to flash. 

1. Connect RJ45 cable to the PoE Switch.
2. The camera is now ready for APP setup when the blue power LED indicatorbegins to flash.

Caution: Do not use power transformers with PoE Setup. CAT.5E UTP/PE RJ45 cable is recommended